Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

reset router password

Unanswered Question
Aug 15th, 2006
User Badges:

I have a cisco 1601 router. I'm trying to reset the password over the console port, but I'm having some trouble, I've never done this before. I'm trying to follow the directions in a pdf I found, but the router is saying the config-register command doesn't exist.

Easton>confreg 0x142

Translating "confreg"

% Unknown command or computer name, or unable to find computer address

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
abdel_n Tue, 08/15/2006 - 16:44
User Badges:


1) - Before reloading, note the value of the configuration register from "show version" command, generally 0x2102

Router#sh ver


Configuration register is 0x2102

2) - reload the router:


if havenot the access to the router (lost password) make a cool boot

3) - Type the break sequence during bootup to enter the ROM monitor mode (ROMMON):

"ALT-B" or "ALT-C"

4) - Use "confreg" command to change the value of the configuration command to make the router ignore the startup configuration in the next bootup:

Rommon1>confreg 0x2142

5) - reboot by typing:


6) - Break the setup system config dialog or type "n" to not erase the NVRAM Backup config file

7) - restore your startup config and change the password

8) - Now you can restore the config registry value from 0x2142 to 0x2102:

Router(config)#config-register 0x2102

!!!!NOTE that with a physical access to the device you can do everything you want, so first and before anything make sure that your devices are physically secured!!!!

I hope this will help you!


This Discussion