×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

10 gig xceiver in Sup V 10Ge Sup Engine

Unanswered Question

I am using an X2-10GB-LR 10 gigabit singlemode xceiver in a Sup V 10GE engine. I am getting low levels across my link. I would like to know if there is any means of optimizing the optics. Via software or otherwise. I have verified that I am transmitting at a level well within the Cisco documented acceptable range, but it would be very helpful if I could tweak it to be as close to the max level as possible.

Presently I cannot find where I could do that or any documentation that supports the ability to do that.

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion