×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Attendant console DN routing

Unanswered Question
Aug 22nd, 2006
User Badges:

Hello,

I am trying to use AC huntgroup to route to different DNs. When I try to add the DN it says invalid DN, but the DN exists and it is in the correct partition. I am using ccm4.1(3)sr2

any ideas....

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gogasca Tue, 08/22/2006 - 14:48
User Badges:
  • Green, 3000 points or more

Have seen this error before, but in earlier versions.

DOnt remember a report for the one you are using.

This DN is a Line for an IP phone?

No Unassigned DN?

Try recreating the Hunt Group.

Or re-adding it.


mrugeshpatel_2 Wed, 08/23/2006 - 04:36
User Badges:

I tried recreating the huntgroup, yes the DN is part of the IP phone.

Zin.Karzazi Wed, 08/23/2006 - 05:38
User Badges:
  • Silver, 250 points or more

So other DNs works fine just the one DN you mention is the problem? try deleting the DN and recreate the line again. if this doesnt help: restart the TCD Service and try again.

Remember to rate helpful posts

Zin Karzazi

Actions

This Discussion