Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
199
Views
0
Helpful
1
Replies

Call rollover from gateway to gateway with SIP

pbogomolnyi
Level 1
Level 1

‎08-23-2006 09:52 AM - edited ‎03-18-2019 06:17 PM

I am trying to make an outbound fax (from RightFax) roll over to GW#2 in case no PSTN trunks are available on GW#1. RightFax only supports SIP and I created a voip dial peer for destination 91T with preference 3 so it would take effect if pots dial-peers are unavailable. Debug dialpeer shows that GW#1 picks correct (SIP) dialpeer, but nothing shows on GW#2.

Any thoughts would be appreciated.

Pavel Bogomolnyi

Labels:
0 Helpful
1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

‎08-23-2006 12:13 PM

Try the following commands on GW#2:

enable

conf t

voice service voip

allow-connections sip to h323

exit

Hope this helps. If so, please rate the post.

Brandon

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents