hani_altaher Mon, 08/28/2006 - 05:37
User Badges:

if i want to use dial peer for routing call when WAN failoure do i need H323 configuration or MGCP (MGCP call fallback and application default ,alteran app)?

jslagle77 Mon, 08/28/2006 - 07:33
User Badges:

To start you will need to have at least something to this effect on a MGCP gateway:


General SRST GUIDELINES - Basic


application

global

service alternate Default


ccm-manager fallback-mgcp


dial-peer voice 1 pots

preference 1

service mgcpapp

destination-pattern 9T

progress_ind setup enable 3

incoming called-number .

direct-inward-dial

port 0/0/1:23

!

!

!

call-manager-fallback

secondary-dialtone 9

max-conferences 8 gain -6

transfer-system full-consult

limit-dn 7940 2

limit-dn 7960 4

ip source-address (Gateway IP Address)port 2000

max-ephones XX

max-dn xxx dual-line preference 1

system message primary Phone System Fallback

voicemail XXXXXXXXXX



This is just a start and you will need to customize it to fit your environment. But this will at least get you started....

hani_altaher Mon, 09/04/2006 - 23:05
User Badges:

thank you very much for your assistance.but i used H323 only So can H323 configurations to be sufficient for SRST to work as Expected without MGCP configuration

Actions

This Discussion