×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Can a FXS register to callmanager 4.1.3

Unanswered Question
Aug 31st, 2006
User Badges:

I am setting up a 2851 router at a remote site and I have a lan-to-lan tunnell set up back to the main campus where I am running CM4.1.3. I have 7912's working perfectly at the remote site homed back to the CM. I also have a 4 port DID/FXS board in the router and want to hook up analog devices (like a fax) to it and be able to throw calls from the main campus to it (and vice versa) I am not getting the config correct and could really use some help.


The fax DN I want to use is 5931.

Currently at my main location I only have DHCP access to a different ISP to test my VPN tunnel, but at the final destination I will have static addresses.

I am attaching the config.

There is probably a bunch of really bad commands in there after 2 days of troubleshooting.



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Brandon Buffin Thu, 08/31/2006 - 06:27
User Badges:
  • Purple, 4500 points or more

You will need to configure the gateway in CCM as described in the following link. The dial peers you currently have will not be necessary as this will be handled by CCM.


Configure MGCP Gateway and FXO/FXS Ports on a Cisco CallManager Server

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017825e.shtml#tasks4x


Also, see this link regarding MGCP gatway configuration in IOS:


http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chapter09186a00805583bd.html


Hope this helps. If so, please rate the post.


Brandon

Actions

This Discussion