×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
leonvd79 Thu, 08/31/2006 - 23:34
User Badges:
  • Silver, 250 points or more

Hello,


I assume your talking about static routes here. Say we want to forward traffic for 172.16.0.0/16 throug gateway 10.32.0.245.


The configuration would be:


conf t

ip route 172.16.0.0 255.255.0.0 10.32.0.254

end


Verify your route


sh ip route 172.16.0.0


HTH


--Leon


* Please rate posts.

ankbhasi Fri, 09/01/2006 - 00:31
User Badges:
  • Cisco Employee,

Hi Friend,


Make sure you enable "ip routing" on global config mode.


Regards,


Ankur

mamta.gohil Fri, 09/01/2006 - 04:02
User Badges:

Dear Ankur


does every switch support this command b'se I have listerned that EMI Switch support this and for SMI we need IOS version such that it support this command


Kindly Guide


Regards


Mahesh

ankbhasi Fri, 09/01/2006 - 07:18
User Badges:
  • Cisco Employee,

Hi Mahesh,


ALL layer 3 switches like 3550 and above support basic routing so "ip routing" command will be supported no matter it is SMI or EMI.


Yes SMI only suppor tbasic routing like intervlan routing, static routes and rip but if you want ospf , bgp and other davance stuff you need to have EMI.


Hope that helps.


Regards,


Ankur

ankbhasi Mon, 09/04/2006 - 07:43
User Badges:
  • Cisco Employee,

Hi Mahesh,


Though the model you are having is SMI but the image which you are running is EMI image which is possible if you upgrade your SMi switch with EMI lisence and that is the reason it supports OSPF.


If you check your image it is "c3550-i5q" so check the number "5" which states its an EMI image.


Check these lines from 3550 release notes


"You can use the show version privileged EXEC command to see the software version that is running on your switch. The second line displays C3550-I5Q3L2 for the enhanced multilayer software image (EMI) or C3550-I9Q3L2 for the standard multilayer software image (SMI)."


HTH


Ankur





Actions

This Discussion