×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Immediate Divert

Unanswered Question
Sep 5th, 2006
User Badges:

Hi I'm trying to implement this feature, but it seems to be working backwards. I've setup the softkey template on myself, however if I'm on the phone and I receive another phone call, I hit the Ivert button, then the person who I was talking too is sent to VM, instead of the new call. Can anyone point me in the right direction? Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
tbramwe Tue, 09/05/2006 - 05:04
User Badges:
  • Silver, 250 points or more

James:


When iDivert is selected it can function both as an immediate feature for new calls and to divert calls-in-progress. For stacked calls and call waiting try selecting the call from the toggle menu on the phone prior to diverting it.


See the features and services guide for more information (this one is for CCM 4.1(3)):

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f3b88.html


Tom

Rob Huffman Tue, 09/05/2006 - 05:20
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi James,


This can be expected behaviour depending on the Softkey template. Have a look at the following;


Because the iDivert softkey does not automatically get configured in a softkey template, use the Softkey Template Configuration window in Cisco CallManager Administration to configure the iDivert softkey in any available softkey template. You can configure the iDivert softkey in the following call states:


Connected


On hold


Ring in




--------------------------------------------------------------------------------


Note The ring-in state in the softkey template represents the call-offering state in the phone call state.


From this good doc;


Cisco CallManager Features and Services Guide, Release 4.1(3)


Immediate Divert


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f3b88.html



Assign the iDivert softkey to the Standard User or Standard Feature softkey template. Assign the softkey in the Connected, On Hold, and Ring In states.


Softkey Template Configuration


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed6f5.html#wp20138


Hope this helps!

Rob


Please remember to rate helpful posts.....


jalston45 Tue, 09/05/2006 - 09:40
User Badges:

Thank you both this helps a lot, however I don't see where I can rate your posts, so I'll just say it here


5.0

Actions

This Discussion