×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
desai.jaideep Fri, 09/08/2006 - 00:21
User Badges:
  • Gold, 750 points or more

Hi


First of all pls tell its for voice or data?


Regards


JD

mamta.gohil Fri, 09/08/2006 - 02:13
User Badges:

it is for data jaideep


config may


controller E1 1/0

framing NO-CRC4

pri-group timeslots 1-31


or anything else required




regards


mahesh




desai.jaideep Fri, 09/08/2006 - 02:43
User Badges:
  • Gold, 750 points or more

Hi


Since you are configuring for data...the config will be "channel-group".

I configure for Rel. or Tata 2Mbps e1 unframed mode like following:


contr e1 1/0

channel-group 0 timeslots 1-31 speed 64

framing no-crc4

linecode HDB3

clock source line


serial 0/0:15

ip add


And this works.


Hope that helps.Pls revert back in caseof any prob.


Pls rate helpful posts.


Regards


JD

mamta.gohil Fri, 09/08/2006 - 21:53
User Badges:

dear jd


i think there is issue with provider link


anyway thanks for your support


regards


mahesh

Actions

This Discussion