09-08-2006 06:19 AM - edited 03-03-2019 04:52 AM
I am trying to run a distributed simulation on a closed network and I have been having some issues. I moved all of my machines participating in the simulation to the same switch (cisco 2950) but I notice that a few of the ports have faulty links only while the simulation is running. I do not believe that this is being caused by a bad piece of hardware but I am not ruling it out either.
I would like to know what else can cause a link to be faulty so that I can continue my investigation into the problem?
Any help is appreciated and thanks in advance,
Jason
09-14-2006 05:56 AM
If a port is in the faulty state, it indicates a hardware problem. Issue the show test
09-15-2006 02:28 AM
you can run "show post" command to detect any hardware problem on 2950.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: