×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

2 PIx 501's and a Pix 506e VPN Mesh

Unanswered Question
Sep 8th, 2006
User Badges:

Hello all,

I need to setup a Pix to Pix to Pix mesh. I've been trying to establish a connection between 2 of the devices for the past 3 days and I'm hoping I an get a bit of help. I've followed the pix to pix to pix mesh guide at http://www.cisco.com/warp/public/110/pixmeshed.html but to no avail.

Here are the configs for 2 of the pix's the third I'll gain access to on Monday.

As you can see the Largo one is also in use as a VPN device for client VPN's also.

Currently I have debug turned on but I'm not getting any info from that. I've also

Any help is greatly apreciated.

I currently have debug crypto ipsec sa and debug crypto isakmp sa running but I'm not seeing anything, and the output of the show crypto ipsec sa command blank and the show crytpo isakmp sa command show no devices listed at all.


Thanks in advance


Mark Irwin


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion