E1 with PABX

Unanswered Question
mheusinger Tue, 09/12/2006 - 00:57
User Badges:
  • Green, 3000 points or more

Hi,


you could start going through

"Cisco IOS ISDN Voice Configuration Guide"

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_book09186a008020eca4.html

OR f.e. "Cisco IOS Voice, Video, and Fax Configuration Guide"

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_book09186a0080080ada.html


You would probably also need some voip config, but without further details it is hard to recommend a specific document.


Regards, Martin

hi Martin,


actually PABX support CCS signaling, and it direcly connected to my router E1 interface,

here is my config i donno but somhow its not working


controller E1 0/0/0

framing NO-CRC4

clock source internal

ds0-group 0 timeslots 1-14 type ext-sig

!

!

voice-port 0/0/0:0

timeouts call-disconnect 3

!

!

voice-card 0

codec complexity high

no dspfarm

!

!


i didn't configure any dial plan coz i think i first get that working

EI is up without any error

when i run


show voice call summary

============== ======== === ==================== ======================

0/0/0:0.1 - - - S_TRUNK_PEND

0/0/0:0.2 - - - S_TRUNK_PEND

0/0/0:0.3 - - - S_TRUNK_PEND

0/0/0:0.4 - - - S_TRUNK_PEND

0/0/0:0.5 - - - S_TRUNK_PEND

0/0/0:0.6 - - - S_TRUNK_PEND

0/0/0:0.7 - - - S_TRUNK_PEND

0/0/0:0.8 - - - S_TRUNK_PEND

0/0/0:0.9 - - - S_TRUNK_PEND

0/0/0:0.10 - - - S_TRUNK_PEND

0/0/0:0.11 - - - S_TRUNK_PEND

0/0/0:0.12 - - - S_TRUNK_PEND

0/0/0:0.13 - - -


thanks

asim


Actions

This Discussion