Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
550
Views
0
Helpful
2
Replies

E&M to channalized E1 circuit - how to connect remote analog voice lines

ahanczak
Level 1
Level 1

‎09-14-2006 04:16 AM

Hi,

I have the following configuration: the 4-wire voice lines are installed in one location. The lines are connected to the Voice E&M interfaces on a 3700 Cisco router. In the other location (2000 miles away, connected by the WAN - T1 line) I have a Hoot and Holler system equipped with an E1 G.703 interface. Is it possible to establish the voice connection between those 2 locations? What hardware I would need to connect the H&H system. Currently I have in both locations just E&M interfaces and I am connecting current H&H system using analog line (4wire) interfaces.

I will really appreciate any help (hints how to solve my problem).

Andrzej

Labels:
0 Helpful
2 Replies 2

PETER NEGUS
Level 1
Level 1

‎09-21-2006 07:19 AM

Without looking in detail at the spec of the H&H it is hard to be exact, but I would try configuring the digital interface to CAS (R2 or similar) and then using "connection trunk" - see

http://www.cisco.com/warp/public/788/signalling/trunk_config.html

Peter

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents