09-19-2006 02:30 AM - edited 03-03-2019 05:06 AM
I tried to configure ip address on an ESW interface and got this message: % IP addresses may not be configured on L2 links. Is there a work around this? How do i get to use this interface.
09-19-2006 02:40 AM
hi
AFAIK you can configure SVI and assign ip address to that.once you are up with that then make the l2 ports to be the member of that particular vlan.
regds
10-17-2006 11:06 PM
Hi,
I have a cisco857 and I cannot setup an IP in any fastethernet address. I get the same msg
'IP addresses may not be configured on L2 links'.
Can not we put an IP in a f0 interface?
Thank you.
10-18-2006 01:51 AM
can you post the existing config
Narayan
10-18-2006 03:06 AM
Hi royalblues,
thank you for reply, I will post the config tomorrow.
Do you think if I create a VLAN for all fasteth interfaces, afterwards I can assign an IP?
many thxs
kike
10-23-2006 09:07 AM
With my 857 I achieve it creating a VLAN or just assigning to VLAN1 the ethernet interfaces.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
