cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
912
Views
0
Helpful
9
Replies

Unable to Load NAM Module - showing PwrDown

neiljbooth
Level 1
Level 1

I have a NAM Module installed in a Cat 6509 and I am unable to bring it online.

The Show Mod command shows that the module is in the PwrDown status.

If I reset the module by reseating it in the chassis I get a logg message saying:

%C6KPWR-SP-4-DISABLED: power to module in slot xx set to off (Module Failed SCP dnld).

Does this mean that the module has a fault or is there a way to recover?

PS - I have tried reloading the whole switch and it makes no difference.

Thanks

9 Replies 9

glen.grant
VIP Alumni
VIP Alumni

If this is hybrid did you try the "set module power up " command ?

Hi Glen,

The 6500 is running IOS, do you know if there is an equivalent command?

You can try hw-module module X reset . X is your module number . I doubt there is a problem with the nam just sounds like the mod is powered down.

I tried this and it didn't make any difference.

Anybody have any other ideas?

vill_21
Level 1
Level 1

Hi,

Can you verify if there is enough power to support the module? Just a guess.

Vilas

Not applicable

Not applicable

Not applicable

pauvo
Level 1
Level 1

Check your catos version and check to see the minimal required code to run NAM module. It probably powered down because the SUP did not recognized it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco