×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

NM-2CE1T1-PRI module not able to be detected on C3640 module

Answered Question

Hi,

I have a problem here when i connect this module NM-2CE1T1-PRI to a C3640 Model(C3640-JK9S-M) , IOS ver 12.1,


I got this error:

Unsupported I/O Controller (type 926) in I/

O Bay. The I/O Controller network interfaces will be unavailable.


WHat is this due to ?


thanks!

Correct Answer by jbayuka about 10 years 10 months ago

The Cisco E1/T1 ISDN PRI network modules are supported in the Cisco 2610-51XM, 2800, 2691, 3660, 3700, and 3800 routers. Refer http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet09186a0080189f95.html for more information.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
amit-singh Tue, 10/03/2006 - 22:03
User Badges:
  • Blue, 1500 points or more

You need atleast 12.3 or 12.3T for this module to be supported on 3600 router.


HTH,

-amit singh

mmirghani Wed, 10/04/2006 - 02:47
User Badges:

Hi

What version of IOS you have ,I think the software you have not compatible with hardware

b-ulrich Wed, 10/04/2006 - 07:22
User Badges:
  • Bronze, 100 points or more

Hi, I ran into this exact problem about 6 months ago. You will need the older NM, which is NM-2CT1-CSU, or the 1 port NM to work in the 3640..These are end of sale, so you will have to find one refurbished.

Actions

This Discussion