×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRST External Calling Number Mask

Unanswered Question
Oct 8th, 2006
User Badges:

Is there a way to mask all outgoing call with the main number on a PRI with a DID block in SRST mode. example Phone 1's external phone number mask is Area code + 7 digit extension say 123 123 1001, extension 2 is 123 123 1002 so on. Main number of business is 123 123 1000, what would be the command/syntax to change the external phone number mask for all calls outbound in SRST mode to main number instead of individual DIDs.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
thisisshanky Sun, 10/08/2006 - 20:55
User Badges:
  • Purple, 4500 points or more

Assuming you have dialplan pattern set, You can setup a translation rule on all outgoing dial-peers.


voice translation-rule 1

rule 1 /1231231.../ /1231231000/


voice translation-profile 1

translate calling 1


dial-peer voice 1 pots

destination-pattern 9T

port 1/0:23

translation-profile outgoing 1



HTH


sankar


PS: please remember to rate posts!

vrana@inetx Thu, 10/12/2006 - 07:08
User Badges:

That worked! I was under the impression that there would be commands under the fall-back section, not realizing that standard translation would do the trick. Thx.

Actions

This Discussion