I have just installed an initial config on a Cisco837 router. I saved the config and restarted and now it wont boot. After decompressing the IOS and just before the warning regarding the crypto etc I get the following message:
*** Watch Dog Timeout ***
PC = 0x80215180, SP = 0x813e9da8
It goes into a constant reboot loop and I cant make it boot. I have gone into rommon and tried to change to confreg 0x2142 to bypass the config but still the same result.
I dont have access to the config analyser on the Cisco site.
Has anyone any ideas / suggestions ?