10-13-2006 07:37 AM - edited 03-13-2019 03:23 PM
When more than one subscriber attempt to contact the unity voicemail, they receive a "not enough bandwidth" error. I have 16 ports configured on the call manager and they are all registered. The unity integration test shows that all ports are reachable. The voicemail ports are all forwared to the next DN. I have also forwarded the last DN to the first DN. I am also seeing in the event log that call waiting tone is detected on one of my voicemail ports. I can't find anywhere that call waiting is configured except on phone DNs. Any help would be appreciated.
10-13-2006 07:46 AM
Hi
'not enough bandwidth' indicates that the device you are calling from is in a different 'location' to the VM ports, and that there isn't enough bandwidth between these two locations to allow the call. Verify that the devices involved are in the correct locations and that your locations CAC is set up correctly.
Regards
Aaron
Please rate helpful posts...
10-13-2006 07:59 AM
I assume you are using Unity 3.X
"Not enough bandwidth" means normally a
Location problem make sure BW is set properly.
Check the integration guide for Unity
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a0080187889.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide