×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Is it possible with just an 828 and a 6015?

Unanswered Question

I'm trying to set up a tiny network between 4 buildings using 828s at each building with a 6015 joining them. I have no need to go anywhere other than between the 828s (no uplink to the rest of our network, or the internet for that matter). All I can get my hands on at this point are the four 828s and the 6015, so I have no ATM uplink... Is this something I can overcome? Suggestions would be GREATLY appreciated! Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thomas.chen Tue, 10/24/2006 - 11:37
User Badges:
  • Silver, 250 points or more

ATM uplink is used as Interface between Local LANs and ATM network.If there is no need for Internet access or remote access ATM uplink is not needed.

Wilson Samuel Tue, 10/24/2006 - 11:49
User Badges:
  • Gold, 750 points or more
  • Community Spotlight Award,

    Mobile User, July 2015

Hi Levi,


Could you please elaborate the matter a bit more. I guess its 828 G.HDSL which is connected to a Service Provider or something which gives an HDSL link to the 6500 Switch.


Moreover what module you are trying to connect to on 6500?


Regards,

Wilson Samuel

Actions

This Discussion