10-19-2006 06:10 PM - edited 03-09-2019 04:36 PM
Hi all,
I use Catalyst 6513 with a module FWSM. I install more policy on FWSM but I can't do. I don't know why. When I install policy, I see a sentence:
Direct failover lan unit [primary or secondary] command will be ignored because MC control only active unit
HTTP error! Make sure the username and password are correct. Otherwise check the network connection status.
deploy result: 0 commands executed, 1 error(s)!
Deploy task failed!
If you know the cause, please answer me early.
Thank you very much.
Duy Khang
10-19-2006 09:57 PM
Kind of strange message. The failover commands are part of the system context which is not haldled/administrated with VMS. Usually you just push a policy on a FW context (Virtual firewall).
Do you use a single context mode or multiple context mode ?
What exactly have you changed in the policy ?
sincerely
Patrick
10-19-2006 10:07 PM
Dear Patrick,
I only add some service in policy such as adding service http_proxy to rule. I don't change any thing.
10-19-2006 11:10 PM
Do you use a single context mode or multiple context mode ?
10-19-2006 11:20 PM
I don't understand the question. I use FWSM (version 2.3), you can tell more clearly
10-22-2006 07:01 PM
Dear sir,
I don't know if Cisco VSM isn't compatible with java?
Please answer me FWSM v2.3 will be compatible with the version of java?
Thank you very much
I am looking forwarding your answer
Duy Khang
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide