Hi Carlo,

just define a new IOS-template in "Configure -> Templates" a new template named e.g reload_APs and enter the following in the "Costum Values"

reload

y

Then save this template.

Change to the Tab "Jobs", create a new jobtype "Config Regular" enter a jobname e.g reload_1131 and click on "Config Job".

Then follow the steps.

In Step 2 use the previously created template reload_APs and proceed with the steps 3-5.

I have tested this with my 1200, 1231 and 1242.

It is working fine.

Best regards,

Frank

P.S. Pleas rate helpfull posts