×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

mrm - "Monitor source address is not configured"?!

Unanswered Question

Greetings,


I'm trying to use MRM, but the "manager" doesn't seem to know it's source address, despite looking like it does.


I've tried multiple source interfaces.

-----------------------------------------ip mrm manager TEST

manager Serial0/0.1 group 225.0.0.1

senders 1

receivers 2

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/1.0.0.1 is not running

Beacon interval/holdtime/ttl:60/86400/32

Group:225.0.0.1, UDP port test-packet/status-report:16384/65535

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

-----------------------------------------

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------


???!!!! Another interface (loopback)

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/3.3.3.3 is not running

Beacon interval/holdtime/ttl:5/86400/32

Group:239.0.0.1, UDP port test-packet/status-report:50000/50001

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------


I've tried this on various 3640s running enterprise 12.3, and a 2500 running 12.2(32). All have the same result.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion