AP stuck in startup - output

Answered Question
Oct 27th, 2006
User Badges:

Hi, anyone can help on this ?


I power cycle my Cisco Access Point (Aironet 1200 series) connected thru console cable to my PC.


On Hyperterminal, I notice that after certain initialization outputs the startup process 'freezes' always at the same point. I already did power cycle the device multiple times, no improvement.


I use my console cable and PC to successfully manage other devices, therefore I am ruling out that as being the problem.


Any ideas why this is happening to my access point and how can I fix it ?

Please find attached output of hyperterminal captured at the moment where the output from the startup 'freezes'.


Attachment: 
Correct Answer by Stephen Rodriguez about 10 years 9 months ago

What settings to do you have on your terminal emulator? Should be 9600, none, 8, 1 and no flow controll.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
scottmac Sat, 10/28/2006 - 05:30
User Badges:
  • Green, 3000 points or more

Is the AP operational? Can you connect to the WebGUIthrough either the Ethernet port or wirelessly?


Do you have flow control set to "None" on our HyperTerminal?


Let us know

Scott


Correct Answer
Stephen Rodriguez Sat, 10/28/2006 - 10:20
User Badges:
  • Purple, 4500 points or more

What settings to do you have on your terminal emulator? Should be 9600, none, 8, 1 and no flow controll.

news2010a Mon, 10/30/2006 - 07:25
User Badges:

Hmmm, I think it was the Hyperterminal setting. I put 'no flow control' and that did it. Thanks all.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode