×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Upgrade/replace phone model on CCM 4.2

Unanswered Question
Nov 8th, 2006
User Badges:

I need to upgrade/replace phone model on ccm 4.2, somthing like 100 x C7905 is going to be replaced with 100 x C7940, but all other phone settings must survive transition.


What is the simplest/easiest method ? Except obvious - retyping it all manualy.


Thanx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Javier Perez Lledo Wed, 11/08/2006 - 02:33
User Badges:

Hi,


The best solution is using the BAT tool. It is not obvious, but you'll get it.


Regards


JAVI

Rob Huffman Wed, 11/08/2006 - 16:21
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Dubravko,


I would look into using the BAT Export utility. You should be able to edit the .csv file created from the Export, scan in the new mac's from the 7940's and then insert them in bulk. Have a look;


Working with the Export Utility


Bulk Administration Tool User Guide, Release 5.1(4)


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_user_guide_chapter09186a00803f4f29.html#wp1086410


Hope this helps!

Rob


Please remember to rate helpful posts.....

Actions

This Discussion