PIX501: Site-to-Site VPN problem

ahmet-saat · ‎11-08-2006

Hi pals.

As you will see on the topology that i have attached, I have 2 PIX and i have already configured them for Site-to-Site VPN. I can monitor that there is an IPSec and IKE tunnel between 2 PIXes. But here is the problem, the hosts on both sides cannot reach each other.

Thanks in advanced.

jmia · ‎11-08-2006

Hi

Take a look here to verify:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094761.shtml

Hope this helps and pls rate posts if it does!

pmajumder · ‎11-08-2006

Hello,

Check your route statements, specially on Pix1, and also if possible post the output of sh route from both Pix's

Regards

Pradeep