11-10-2006 02:35 AM - edited 02-21-2020 01:18 AM
Hello,
i try to configure two ASA5510 in a failover szenario. After I have already finished the setup on the primary ASA I try to send the configuration to the secondary. Following Error is shown:
"Unable to configure the firewall at XXX.XXX.XXX.XXX for the following reason:
PDM was not able to determine the context mode of the peer at XXX.XXX.XXX.XXX"
Is this a problem of the context mode? Both ASA?s run in single mode or must there be a special Firewall configuration.
Thank you for your support.
11-11-2006 12:31 AM
Hi could you please tell me the physical connection of Fail over?
11-11-2006 01:09 AM
We have connected a crossover cable on the ethernet 0/3 in between both asa interfaces.
11-11-2006 02:58 AM
Can you send the show version output of the firewall?
check the failover license it has?
11-11-2006 04:38 AM
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 25
Inside Hosts : Unlimited
Failover : Active/Standby
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 0
GTP/GPRS : Disabled
VPN Peers : 250
WebVPN Peers : 2
This platform has an ASA 5510 Security Plus license.
They are identical on both ASAs.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: