×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Vlaning from 3560 to 4506

Unanswered Question
Nov 12th, 2006
User Badges:

Is there a way to vlan my 3560's from my wiring closets to the coresponding ports on my 4506? I had a Cisco certified person come in the other night when we set up our 4506 and he was supposed to do this. Any way to check that he did?

thanks

Gary

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Sun, 11/12/2006 - 17:43
User Badges:
  • Purple, 4500 points or more

If it is just one vlan then you would just have to make sure the connecting ports on both switches are set for the same vlan . Check with the "show interface status " command . If mutliple vlans trunked across the link use "show interface trunk" .

gary.hostetler Sun, 11/12/2006 - 18:10
User Badges:

The VLAN is called 1 (from Network Assistant) but would it not use ip addresses? Is 1 all that is needed?

thanks

Gary

glen.grant Mon, 11/13/2006 - 04:25
User Badges:
  • Purple, 4500 points or more

If you are just extending a vlan from 1 switch to another no ip addresses are needed , this is a layer 2 function . If the vlan needs to be routed then that is a different story .

Actions

This Discussion