×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Qsig Issue on CM 4.1(3) (SR2) and 3725

Unanswered Question
Nov 15th, 2006
User Badges:

Hi,


we have the following setup:


Call Manager 4.1(3) SR2

and we are using CCM (6500) via MGCP to connect to a Cisco 3725 via Qsig.


This Terminates on a 3745 connected to a Siemens Hicom also via Qsig.


Calls going to this destination are fine if they are answered by the originally called Extension.

If the called Extension has a Call Forward on no reply to a VM or another extension the call, when answered last's for around 5-6 seconds and gets then terminated.


The cause for the Termination is:


Cause i = 0x80E6 - Recovery on timer expiry


I have checked on the web for 2 suggestions. One was a 60000 T310 Timer (already set) and the other one was adding overlap on the Route Pattern




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
Loading.

Actions

This Discussion