×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

vic card not registering

Unanswered Question
Nov 21st, 2006
User Badges:

I have a production 2851 gateway with call manager 4.2.3. I have added a vic2-2fxs card to one of the slots, 0/2/0, and have done the "update / reset gateway" through ccm, and the "no mgcp / mgcp" commands on the router. However, the card does not register with call manager. Since this is an addition, do I have to use "ccm-manager config" ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pbarman Tue, 11/21/2006 - 18:44
User Badges:
  • Silver, 250 points or more

Often I have to do the "ccm-manager config" command to successfully register the gateway after such a change.


ccm-manager config

no mgcp

mgcp


Once gateway registered:


no ccm-manager config


Make sure to do this during a downtime.

Actions

This Discussion