11-29-2006 12:59 PM - edited 07-03-2021 01:18 PM
I have everything configured, but I cannot find an option to enable the radio on my 1242LAP. I don't find the option consoled in in enable mode, and I cannot find an option in the WLC.
Where do I go to turn on the radio?
11-29-2006 01:21 PM
Okay, after reading acouple of other messages, I see that the AP is only taking 4W of power, and giving me the low power source error on boot.
I am using a linksys SRW224P PoE switch to power them, capable of doing 12 ports at 15.4 W. How do I tell the LAP to ignore this error and request full power?
11-29-2006 02:41 PM
Found my answer
config ap power pre-standard enable
config ap power injector enable
Do that on the controller and life is good.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: