11-29-2006 12:59 PM - edited 07-03-2021 01:18 PM
I have everything configured, but I cannot find an option to enable the radio on my 1242LAP. I don't find the option consoled in in enable mode, and I cannot find an option in the WLC.
Where do I go to turn on the radio?
11-29-2006 01:21 PM
Okay, after reading acouple of other messages, I see that the AP is only taking 4W of power, and giving me the low power source error on boot.
I am using a linksys SRW224P PoE switch to power them, capable of doing 12 ports at 15.4 W. How do I tell the LAP to ignore this error and request full power?
11-29-2006 02:41 PM
Found my answer
config ap power pre-standard enable
config ap power injector enable
Do that on the controller and life is good.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide