12-04-2006 11:24 AM - edited 03-14-2019 07:04 PM
Does anyone have a sample SCCP configuration for a VG224 Gateway? I have the device set up in CallManager, but I know my configuration on the Gateway is probably not right. Can anyone help? Thanks
12-04-2006 02:53 PM
12-05-2006 07:02 AM
Thanks for the reply...however this configuration is for MGCP, does anyone have one for SCCP?
12-05-2006 07:09 AM
Try this
stcapp ccm-group 1
stcapp
!
voice-port 2/1
caller-id enable
!
voice-port 2/2
caller-id enable
!
sccp local FastEthernet0/0
sccp ccm 1.1.1.1 identifier 1
sccp ccm 1.1.1.2 identifier 2
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
associate ccm 2 priority 2
!
dial-peer voice 1pots
service stcapp
port 2/1
!
dial-peer voice 2 pots
service stcapp
port 2/2
HTH
Sankar.
PS: please remember to rate posts!
12-05-2006 08:22 AM
It's still not working correctly. Is there more to this config that is missing? As soon as I pick up the handset I get a busy signal.
12-05-2006 08:47 AM
Can you paste a sh sccp output ?.
12-05-2006 09:04 AM
SCCP Admin State: UP
Gateway IP Address: 10.1.40.6, Port Number: 2000
IP Precedence: 5
User Masked Codec list: None
Call Manager: 10.1.40.11, Port Number: 2000
Priority: N/A, Version: 3.1, Identifier: 11
Call Manager: 10.1.40.10, Port Number: 2000
Priority: N/A, Version: 3.1, Identifier: 10
SCCP application services(dspfarm profiles) are not enabled
or haven't associated to SCCP CCM group
12-05-2006 09:36 AM
Alright, got this working now. Anyone looking to do this configuration, please refer to this document.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide