12-08-2006 07:56 PM - edited 03-05-2019 01:15 PM
HI! i need help fast!!! how can i connect to a 2520 router console and with what program and settings! i have the cable, but nothing is showing up under hyper terminal!! thx!
12-09-2006 05:43 AM
hi
12-09-2006 06:38 AM
Hyperterminal should work OK. You (usually) want it set for 9600, 8 data bits, no parity, one stop bit (9600, 8, N, 1 ) and you want NO FLOW CONTROL (no software, no hardware ... none ... unclick everything).
I say "usually" because some routers bought used may have been reloaded through the serial port, and the person that reloaded it may forget to reset the terminal parameters.
If "9600,8,n,1" doesn't work, try 115K and work down from there.
Good Luck
Scott
12-10-2006 01:57 PM
This question was also posted on the WAN Routing and Switching forum where it has gotten several responses. I suggest that we consolidate the discussion in that forum.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: