×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SVC Problem on ASA 7.1(2)

Unanswered Question
Dec 10th, 2006
User Badges:

I tried to configure SVC (tunnel-mode) on ASA 7.1(2) and I reach the stage where I can connect with the SSL VPN but I can?t access any resources in the network.


Below is the configuration, appreciate any helpful assistance..



access-list WebVPN-ACL standard permit host 0.0.0.0


group-policy Partners internal

group-policy Partners attributes

dns-server value 10.100.13.100 195.226.224.74

vpn-tunnel-protocol IPSec webvpn

split-tunnel-policy excludespecified

split-tunnel-network-list value WebVPN-ACL

webvpn

deny-message value "Don't Ever Try"

svc enable

svc keep-installer installed

svc rekey time 30

svc rekey method ssl


tunnel-group WebVPN-Tunnel type webvpn

tunnel-group WebVPN-Tunnel general-attributes

address-pool WebVPN-User

default-group-policy Partners

tunnel-group WebVPN-Tunnel webvpn-attributes

group-alias Partners_department enable


webvpn

enable outside

svc image disk0:/sslclient-win-1.1.2.169.pkg 1

svc enable

tunnel-group-list enable


Regards,

Belal

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
r.vdoever Tue, 12/19/2006 - 13:25
User Badges:

Define your internal networks in the split-tunnel acl, eg:

access-list WebVPN-ACL extended permit ip 10.100.13.0 255.255.255.0 any

no split-tunnel-policy excludespecified

split-tunnel-policy tunnelspecified


Actions

This Discussion