12-13-2006 07:44 AM - edited 03-05-2019 01:19 PM
I have a Switch type WS-C2950T-48-SI with a software version 12.1(22)EA4-C2950-I6Q4L2-M.
In this Switch i need to apply an extended ACL to an interface for a PC that was just Added.
Now, i'm able to add the ACL's in global configuration mode, but when i go to any interface and try to give the command "ip access-group ...", but my switch does not recognise this command. When i give "ip ?" it does not show the command Access-Group to any interface.
Could this be an IOS upgrade problem or am I missing something?
12-13-2006 07:52 AM
Hi Kled,
juz upgrade the IOS & do, it works fine, since this IOS doesn't support interface based ACL thatz the reason it couldn't recognize the "ip access-group" command.
12-14-2006 01:59 AM
Hi Friend,
You need to run the enhanced image to support the access-lists.
See the link for details
HTH, rate if it does
Narayan
12-14-2006 05:47 AM
Thanks for replying.
Any hint on what is the code i should look for in the enhanced image name that would work with my Switch.
Regards
Kledi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: