×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Can only open some ports?

Unanswered Question
Dec 15th, 2006
User Badges:

I'm a bit of a Cisco newbie and I'm hoping someone can offer me a little assistance. I have a Cisco 851W which I have configured using SDM express. Everything is working fine with the device, with one exception. I am apparently only able to open certain pinholes in NAT.


I want to foward ports 80, 443, and 3389 from the WAN interface to a server on my LAN. But after configuring the port forwarding, I am only able to access the server on port 80. Ports 443 and 3389 remain closed. Any thoughts on why that might be? Thanks for your assistance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Sun, 12/17/2006 - 22:13
User Badges:
  • Red, 2250 points or more

Hi


Can you post the current running config of your router ?


regds


zacmutrux Sun, 12/17/2006 - 22:23
User Badges:

Thanks very much for your reply. I'm not sure what I did to fix my problem, but it appears to be resolved now. Thanks just the same.

Actions

This Discussion