Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

7970 firmware load - which file is it ?

Unanswered Question
Dec 19th, 2006
User Badges:

I am using callmanager express 4.0 and wish to update the firmware loads on a 7970g phone, I have downloaded the latest updates as shown below :






After extracting all the files into flash, I configured all the files under tftp-server flash: as shown

tftp-server flash:cnu70.2-7-6-26.sbn

tftp-server flash:CVM70.2-0-2-26.sbn

tftp-server flash:Jar70.2-9-2-26.sbn

tftp-server flash:TERM70.7-0-3-0S.loads

tftp-server flash:term70.default.loads

But I am unsure as to which file to load under telephony-service for "load 7970 filename" ???

Checking ciscos link for more information about updating the 7970 at


It says : "Read the "Read Me" files included with Cisco software updates. These files provide important updated information about installing and configuring the new software." but there is no readme file with the firmware update ?

A bit confusing any help would be appreciated ?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Rob Huffman Tue, 12/19/2006 - 12:15
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Mark,

Perhaps this will help, I am pretty sure that you would use;

load 7970 TERM70.7-0-3-0S

Upgrading Individual Phone Firmware Files

From this good CME doc;


Hope this helps!


Please remember to rate helpful posts.....


This Discussion