×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Outgoing dial-peer on CME problem

Unanswered Question
Jan 18th, 2007
User Badges:

Dear all,


I have 2 dial-peer


dial-peer voice 1 pots

destination pattern 9........

port 1/0/0


dial-peer voice 2 pots

destination pattern 9001T

port 1/0/0


When I dial 9xxxxxxxx, it work. But when i dial 9001xxxxxxxx. The call become 9001.....; it go to dial-peer 1.


How can I use dial-peer 2 to make 9001 call.


Thanks


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2.5 (2 ratings)
Loading.
Tony Huynh Thu, 01/18/2007 - 23:18
User Badges:
  • Silver, 250 points or more

Hi,


The dial-peer hunting algorithm does a digit by digit analysis and will match the first dial-peer that is a possible match. What is the first dial-peer meant to match?

Here are 2 workarounds:

(1) make the first dial-peer the following:

dial-peer voice 1 pots

destination pattern 9T

port 1/0/0


(2) or if it is meant for local calls in the US, then you could use the following and thus it won't match dial-peer voice 1 when you dial an international call


dial-peer voice 1 pots

destination-pattern 9[2-9]......

port 1/0/0


Hope this helps,

Tony

marahman78 Fri, 01/19/2007 - 21:04
User Badges:

Hi,


You can use Preference value to set priority for dial peers.


Thanks

Actions

This Discussion