01-18-2007 10:12 PM - edited 03-14-2019 07:37 PM
Dear all,
I have 2 dial-peer
dial-peer voice 1 pots
destination pattern 9........
port 1/0/0
dial-peer voice 2 pots
destination pattern 9001T
port 1/0/0
When I dial 9xxxxxxxx, it work. But when i dial 9001xxxxxxxx. The call become 9001.....; it go to dial-peer 1.
How can I use dial-peer 2 to make 9001 call.
Thanks
01-18-2007 11:18 PM
Hi,
The dial-peer hunting algorithm does a digit by digit analysis and will match the first dial-peer that is a possible match. What is the first dial-peer meant to match?
Here are 2 workarounds:
(1) make the first dial-peer the following:
dial-peer voice 1 pots
destination pattern 9T
port 1/0/0
(2) or if it is meant for local calls in the US, then you could use the following and thus it won't match dial-peer voice 1 when you dial an international call
dial-peer voice 1 pots
destination-pattern 9[2-9]......
port 1/0/0
Hope this helps,
Tony
01-19-2007 09:04 PM
Hi,
You can use Preference value to set priority for dial peers.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: