Meet-Me Conference Bridge - CCM 4.1

Unanswered Question
Jan 19th, 2007

How can an administrator disconnect a caller from a bridge? Can the administrator view what phones are attached to a meet-me conference? We have a meet-me conference bridge that is stuck in the "open" position. What can be done to disconnect attendees or reset the bridge so all connected calls are disconnect.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
thisisshanky Fri, 01/19/2007 - 17:46

You can try reset the conference bridge from CM admin page and see if that helps. Or best bet is to restart IP Voice media stream service.

birnit Tue, 01/30/2007 - 13:16

Thank you for your response. Resetting the bridge has helped but the problem seems to happen way to often. How do you restart the IP Voice Media Stream Service? I found the service page but the only options are to Update, Set to Default or Advanced. thanks again.

m.yamaguchi Thu, 11/01/2007 - 12:40

Hi Birni,

I have almost the same issue as you have had and I would like to know the following:

Do you know how to reset a specific meet-me that are running in the system?.

i.e: we have 10 meet-me running at an specific period of the day and for any reason, we need to reset a specific one of them. How can we reset this specific meet-me without reset others?.




This Discussion