×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

FWSM

Unanswered Question
sachinraja Mon, 01/22/2007 - 23:02
User Badges:
  • Red, 2250 points or more

Hello aksher


from the 6500 chassis, you can use the session command to enter to the appropriate chassis...


session 4, where 4 is the module number... you need to have the correct modules on the correct slots !!!!


Hope this helps..all the best..


Raj

Patrick Iseli Tue, 01/23/2007 - 06:42
User Badges:
  • Gold, 750 points or more

Refernce:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_2_3/fwsm_cfg/sysmgmt.htm


Session into the FWSM using the command appropriate for your switch operating system:


?Cisco IOS software

Router# session slot number processor 1



?Catalyst operating system software

Console> (enable) session module_number


sincerely

Patrick


Actions

This Discussion