Solved: SNMP Call Count - E1 (VWIC-1MFT-E1)

evantaylor · ‎01-28-2007

I am using a 2801 IOS 12.4(9)T with a VWIC-1MFT-E1 card in it. It is being used with CCM 5.1 for inbound and outbound dialing.

I am trying to graph the total outbound and inbound calls over a given period and have been querying card by walking using OID's under 1.3.6.1.2.1.10.20.1.3.3.1

All my results return 0.

Is this even the correct OID I should be querying?

These are listed as correct for ISDN interfaces, according to http://www.oidview.com/mibs/0/ISDN-MIB.html

I have seen a MIB browser on the Cisco site that also had these listed but can no longer find it.

Thanks in advance,

Evan.

David Stanford · ‎01-31-2007

Have a look at this post to see if it helps:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1ddd05e5/0#selected_message

View solution in original post

David Stanford · ‎01-31-2007

Have a look at this post to see if it helps:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1ddd05e5/0#selected_message

evantaylor · ‎01-31-2007

Thanks for this! Exactly what I was after ...

Under what circumstances would the OIDs that I was previously walking be used? Would it be for data dialling only?