Upgrading a router from the ROMmon prompt using the TFTP functionality of the boot image (Rx-boot or Router(boot)>)


Wed, 11/18/2009 - 18:25
Jun 18th, 2009

Core Issue

The boot image is a subset of the Cisco IOS  Software that is used to download main Cisco IOS Software images to the router using TFTP in recovery situations. The user can interact with this image through a command line interface signified by the prompt Router(boot)#. Some platforms (Cisco 1600, 2500) have it in ROM; others (high-end routers) have it in bootflash. Depending on your platform, this image may be called xboot image, rxboot image, bootstrap image, or boot loader/helper image.

The boot image has limited capabilities. For example, it does not contain routing information.


For step-by-step information on how to upgrade a router from the ROM Monitor (ROMmon) prompt, refer to How to Upgrade from ROMmon Using the Boot Image.

Booting Problems

Boots in boot mode with Router(boot)> prompt

Boots in ROMMON



This Document

Related Content