A WEP Default Key set error 2 error message occurs on a 1220 Vxworks Access Point

Document

Wed, 11/18/2009 - 18:22
Jun 18th, 2009

Resolution

This error message indicates that the update process (upgradaging from VxWorks to Cisco IOS ) is not completed because of low memory in the device. The memory is low due to the loading of the huge .ini file that takes place with the Download All System Configuration option.

The upgrade process may not be successful if the non-Cisco IOS Access Point (AP) has the configuration loaded with the .ini file that was acquired through Download All System Configuration option. Use the .ini file from the Download Non-Default System Configuration option.

For more information, refer to the System Requirements section of Release Notes for Cisco Aironet Conversion Upgrade Image 3.0 for Cisco IOS Software.

Problem Type

Error message

Products

Access point

Security Options

WEP key

VxWorks Errors, Warnings, Statistics and Log Messages

WEP Default Key set error 2

Loading.

Actions

This Document

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode