How to enable or disable provisioning on the DGW in Service Engine 2.0

Document

Jun 18, 2009 3:52 PM
Jun 18th, 2009

Resolution

To enable provisioning on the Data Gateway (DGW), log in to the Command Line Interface (CLI) and perform these steps:

  1. Issue the Telnet <ip address> <port> command to log in to the DGW CLI.
  2. Issue the nehost/dsdgw>context ds-config command to switch the context to data access.
  3. Issue the /dsdgw[ds-config]>close-provisioning FALSE command to enable provisioning on the DGW.

To shutdown provisioning on the DGW, log in to the CLI and perform these steps:

  1. Issue the Telnet <ip address> <port> command to log in to the DGW CLI.
  2. Issue the nehost/dsdgw>context ds-config command to switch the context to data access.
  3. Issue the nehost[ds-config]>close-provisioning TRUE command to turn off provisioning.
Average Rating: 0 (0 ratings)

Actions

Login or Register to take actions

This Document

Posted June 18, 2009 at 3:52 PM
Stats:
Comments:0 Avg. Rating:0
Views:922 Contributors:0
Shares:0

Documents Leaderboard

Rank Username Points
1 54
2 5
Rank Username Points
5