The service compress-config command on the AP does not work

Document

Wed, 11/18/2009 - 18:22
Jun 18th, 2009
User Badges:
  • Gold, 750 points or more

Resolution

You cannot issue the service compress-config command on Access Points (APs) to compress the configuration because this command is not supported on APs. Prior to Cisco IOS  Software Release 12.3(02)JA, the AP accepts the service compress-config command from the user, but the configuration is not compressed. Instead, the configuration may get corrupted. If this happens, the AP fails to boot when you reload the AP. 

In Cisco IOS Software Release 12.3(02)JA and later, the AP issues the Boot ROMs do not support NVRAM compression. Disabling service compress-config message when the command is issued.


Problem Type

Error message


Products

Access point


IOS Errors, Warnings, Statistics and Log Messages

Boot ROMs do not support NVRAM compression. Disabling service compress-config

Loading.

Actions

This Document

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode