cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1689
Views
0
Helpful
0
Comments
TCC_2
Level 10
Level 10

Resolution

A Cisco WGB device does not support multiple VLANs in it.  A 1100 AP, however, that acts in WBG mode can support multiple VLANs in it but with these restrictions:

  • The VLANs must be assigned on both the root AP and WGB sides. On WGB use the command workgroup-bridge client-vlan to configure the VLANs.  On WGB make sure you map each VLAN to an SSID same as the Root AP.

  • The WGB must be connected to a dot1Q-capable switch.

  • The WGB associates as an infrastructure device. The Infrastructure SSID must be mapped to the native VLAN on root and the WGB.

Here are some of relevant URLs

Problem Type

Release notes / product  overview / data sheet / FAQ

Technical product specification / features

Products

Access point

Workgroup bridges

SW Features

VLANs

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: