SPA1xx ATA Resync_At Parameter v1.2.1(004)


Tue, 08/14/2012 - 06:22
Aug 8th, 2012

The SPA1xx ATA firmware introduced the Resync_At parameter in firmware version 1.2.1(004).

This new parameter can affect three SPA1xx ATA settings after a firmware upgrade unless you explicitly

configure these parameters.

These setting do not affect device stability or security in any way.

The affected parameters are:

  • Resync_At__HHmm_
  • Resync_At_Random_Delay
  • Resync_Fails_On_FNF

Eliminate unintended settings by configuring the parameters via a provisioning file or the web‐user

interface as described in the PDF document.

Note: If you factory reset the SPA1xx ATA after upgrading to 1.2.1(004), then the parameters are

correctly set and the above can be ignored.


Chad Monroe Sun, 08/12/2012 - 22:18

How do I gain access to release v1.2.1(004)? All I see in the downloads section is 1.1.x based releases. Thanks.


This Document

Related Content