Workgroup Bridge Standalone AP Support 5GHz ?????

Rahul Wankhade · ‎02-02-2015

Hi Team,

I have below query please help me out for this.

I have 1600 standalone AP configured as Workgroup Bridge (Connected to the WLC base network using the PSK), it’s support 5GHz or it’s only support 2.4 GHz ????

I want 5GHz it’s possible or not ????

Thanks & Regards,

Rahul

George Stefanick · ‎02-02-2015

Yes the 1600 supports both 2.4 and 5. When you configured the wgb did you configure interface 0 or interface 1 ?

Interface 0 is 2.4 and interface 1 is 5 ..

Rahul Wankhade · ‎02-03-2015

Thanks George,

Now 5GHz is up...I am facing another issue I configure ip address dhcp client-id Gigabit Ethernet this commend on the Cisco 1600 AP but automatically this commend remove what is the reason why it's happens ...I also write the configuration but after one day or two days this commends is erase...I am facing the issue with two or three AP's not with all. If this commends erase I am unable to get the ip address my end devices.

Check the attached configuration.

Thanks & Regards,

Rahul